Course Overview
This course covers monitoring, managing and configuring your edge-to-core network with the HPE Intelligent Management Center software platform (HPE IMC). This course teaches how HPE IMC is installed, how devices are added through discovery, and then how they can be viewed. The course also goes through configuration management and explains how HPE IMC is used to manage firmware and configuration on devices. It covers how alarms are received and processed in HPE IMC, along with trap management. Then it looks at the Virtualization Resource Management (VRM) component against an ESXi host. This course teaches Access Control List (ACL) management, Network Traffic Analyzer (NTA), Compliance and Intelligent Policy Center, report management, and VXLAN management. The hands-on lab exercises utilize HPE IMC working with edge devices including HPE Comware, Aruba AOS and CX and Cisco switches. This course is approximately 40 percent lecture and learning activities, and 60 percent hands-on lab activities.
This course is the combination of:
- HQ7C1S: HPE Intelligent Management Center - Managing and Monitoring your Network
- H61N0S: HPE Intelligent Management Center - Securing Network and Performance Management
Moyens d'évaluation :
- Quiz pré-formation de vérification des connaissances (si applicable)
- Évaluations formatives pendant la formation, à travers les travaux pratiques réalisés sur les labs à l’issue de chaque module, QCM, mises en situation…
- Complétion par chaque participant d’un questionnaire et/ou questionnaire de positionnement en amont et à l’issue de la formation pour validation de l’acquisition des compétences
Who should attend
This course is for network administrators and engineers who plan to deploy, manage, monitor and configure their network using the HPE Intelligent Management Center software platform.
Prerequisites
Prior to this course, students should have some networking experience to get the most from this training course. They should:
- Understand networking
- Understand IPv4 addressing
- Have some knowledge of the CLI commands on HPE Aruba Switches (AOS and CX), HPE Comware v7 and Cisco (this knowledge is beneficial, but not required)
- Understand file architecture on HPE Comware and Aruba, including Telnet/SSH, and start up and saved configurations
- Understand SNMP configuration
- Understand traps and how they are configured on the switches
Course Objectives
By the end of this class, you should be able to:
- Understand the HPE IMC installation process and how to initially access HPE IMC
- Understand how to add devices into HPE IMC using auto discovery
- Understand the different views in HPE IMC and how they can be utilized
- Understand the Configuration Centre and how it can be used for configuration management
- Understand how alarms and traps are generated in HPE IMC
- Understand how HPE IMC can be used to manage, monitor and configure VLANs.
- Understand how HPE IMC can be used for performance management
- Understand how HPE IMC can be used for virtualization resource management
- Understand how to troubleshoot HPE IMC
- Implement and deploy Access Control Lists (ACLs) using HPE IMC ACL management
- Configure and use the HPE IMC Network Traffic Analyzer module
- Configure and deploy Compliance Policy Center configuration
- Create and schedule reports
- Configure and deploy static VXLAN tunnels using HPE IMC VXLAN management
Course Content
- Module 1: HPE Intelligent Management Center Introduction
- Module 2: Installation and Initial Access
- Module 3: Adding Devices
- Module 4: Trap Management
- Module 5: View Management
- Module 6: Configuration Management
- Module 7: Alarms and Events
- Module 8: VLAN Management
- Module 9: Performance Management
- Module 10: Virtualization Management
- Module 11: ACL Management
- Module 12: Network Traffic Analyzer (NTA)
- Module 13: Compliance Center and Intelligent Policy Center.
- Module 14: Reporting
- Module 15: VXLAN Management
Moyens Pédagogiques :